This Quarter Scale Pawnee
has been constructed by Mark Hunt.
The kit
is from Model Design in
Its
powered by a Genoah twin 80cc ad has primarily been
built for Aero towing and aerobatics.
The
construction steps are listed below:
Wing
Root receiver installed. Ply doublers top and bottom of joiner
Wing
Joiner Receivers Installed. Ply doublers top and bottom of joiner.
Rudder
built up. ply hardpoints
Elevator
built up with ply hard points.
Horizontal
Stabiliser built up with ply Hard Points
Wing
joiner completion.
Wings
Joined.
Wing
Brace contact points
Carbon
Strengthening lots of ply for Wing center section
How it looks
so far notice wing tip build up. all tips and
control surfaces covered with 3oz carbon (like Rudder in picture) Wings
laminated with .8mm Ply. Leading edge ply with balsa
former, then 3 oz carbon.
Tail
Wheel and Elevator Servo set up
Minimum
Cockpit detail
Cowling
Zenoah 80cc Twin required cutouts for Plugs and
exhaust
Finished
Wing with Struts and cheat cowls over joining points
Hard
points for Wing Strut joining at fuselage
Finished
Product!!!
